2N Analogue UMTS gateway 2N SmartGate UMTS - Manual, 1699 v1.1.0 - Manual (Page 57)

Voice function 4.1
57
Automatic Call ("BabyCall")
If the BabyCall function is enabled on FXS interface, a pre-programmed timeout
is counted down after off-hook. If you don’t start dialing within this timeout, 2N®
SmartGate UMTS signals dialing end and starts to establish a call to the pre-
programmed number using UMTS/GSM network automatically – from now 2N®
SmartGate UMTS behaves as if a standard outgoing call to UMTS/GSM had been
established. Any dialing during the BabyCall timeout cancels this function and a
standard outgoing call can be made.
ME- Mobility Extension
ME function takes place during ringing on FXS interface if 2N® SmartGate UMTS
is programmed as DialThru gateway.
Fill in telephone number for ME function and number of rings to ME function start
on FXO routing table sheet.
1. 2N® SmartGate UMTS detects a ringing signal and immediately interconnects it
to FXS interface – the phone starts to ring.
2. If there is no call connection before the pre-programmed number of rings, 2N®
SmartGate UMTS simultaneously establishes call to UMTS/GSM network. Some
timeout take place between UMTS/GSM call establishing start and ringing of
mobile phone.
3. As long as 2N® SmartGate UMTS detects ringing on FXO interface, connected
analog and UMTS/GSM phones ring.
4. You can receive the call on analog line as well as on your mobile phone.
5. During call received on mobile phone you can send FLASH to PBX, for special
PBX functions, by preprogrammed DTMF code.
If you want repeatedly temporarily disable and afterwards enable the ME
function, fill in Password for ME activation/disabling. If password is filled in:
1. Hook off the phone.
2. For temporarily disabling the function dial the password and confirm by
For activation the function dial the password and confirm by .
3. Hang up.
Tariff pulses 16 or 12 kHz
2N® SmartGate UMTS has tariff pulse transmitter on FXS interface. You can use
tariff pulses for outgoing call pricing. 2N® SmartGate UMTS offer pseudotariff only
– tariff metering doesn’t correspond to real price of call, tariff pulses are
transmitted according to programmed parameters and call duration. You must
program specific parameters in FXS routing table to set tariff metering for different
prefixes of dialed numbers. Tariff metering is transmitted only during calls to
UMTS/GSM network. Connected PBX must provide the tariff metering during calls to
FXO interface.
You can also program 2N® SmartGate UMTS to transmit tariff pulses as call
connect/disconnect signaling if your PBX cannot receive telephone line polarity
reversal signaling.