2N Analogue UMTS gateway 2N SmartGate UMTS - Manual, 1699 v1.1.0 - Manual (Page 39)

Table of Parameters 3.2
39
n Bar the number to be dialed - the calling subscriber tone;
n Route the call to UMTS/GSM network, or to PBX through the FXO interface;
n Accelerate connection establishing by knowing the number length for the
given prefix;
n Accelerate connection establishing by allowing to terminate dialing with a #;
n Modify the number to be dialed by removing and/or adding prefix.
n Set tariff metering for the given prefix
n Set time limit for call
Every table line includes a phone number prefix (of variable length) and other
parameters. The parameters define SmartGate UMTS's behavior in case the
beginning of the dialed number matches this prefix on the same table row. The
table contains 120 rows for up to 120 different prefixes.
There may be exceptions to the rule - a number may start with the same digits but
has to be served in a different way. Any table row that starts with the same prefix
followed by one or more digits is considered an exception of the line with shorter
prefix.
Remember to complete the "Other prefixes" line for a number whose prefix is not
found in the table.
An example in the figure shows how to bar all international calls with the exception
of calls to Slovakia. Calls to Slovakia are routed through FXO interface and the call
is established immediately after 14 digits are dialed. All other calls are enabled and
they are routed to UMTS/GSM network. Their tariff is one impulse every 30 second
and you can accelerate connection establishing by dialing of a # after the dialed
number. Maximal length of the call is 10 minutes.
Operator for Integra Function No.: 405
In some UMTS/GSM networks you can add to dialed number # character and
PBX subscriber number. Subscriber number is displayed on other side together
with CLI. This parameter take place when dialed number doesn't contain #
character. Common parameter for both FXO and FXS port.
Setting options: 0-8 characters (0-9)
Default setting: blank