About menus – 2N OfficeRoute - User manual, 1493 v1.9.0 User Manual
Page 23
23
push Enter.
String – Arbitrary number of characters. The acceptable value interval may be
included in the prompt.
Enter a hostname from 1 to 32 characters: OfficeRoute
Integer – Decadic integral number. The acceptable value interval may be
included in the prompt.
Enter a size between 1 and 100 : 99
Hexadecimal integral number – number to be entered in the hexadecimal format using
characters 0÷9 and a÷f or A÷F.
Enter a hex number between 1h and ffh : 1a
MAC address – Up to 12 hexadecimal digits of the physical address. Zeros at
the beginning can be omitted.
Enter the remote network address : 50C229C4E2
IP address – Internet address in the format of four digits of 0÷255 separated
with dots.
Enter an IP address – 192.168.22.30
As soon as the requested information is entered, the respective operation is executed
and new values are displayed in the redrawn menu.
Some configuration parameters may have just one of two constant values. By selecting
such an item you immediately select a value opposite to that preceding the selection.
Typical examples are
and
parameters. If the value is
, then it becomes
whe
on
off
on
off
n the item is selected and vice versa.
Some commands execute operations that have a serious impact on the behaviour of
the entire system (such as restart). Therefore, the system usually 'makes sure' before
execution that it is really your intention.
If you give an answer other than 'y' or 'Y', the command will
Are you sure [y/n] –
not be executed.
To cancel the command execution and quit the prompt, push the
key any time.
Esc
About Menus…
We shall discuss the serial console menus in detail in the sections devoted to the
gateway parameter settings. Below is a brief survey of these menus only.
Main menu
Appears after the USB cable is connected to the terminal (sometimes you must push E
).
nter
Configuration menu
Contains six submenus – network configuration, serial console settings, command line
configuration, calls and device states, reboot and settings of VRRP and DHCP.
Network configuration
Used for setting the gateway IP address, network mask, initial router, DNS addresses,
network name and domain.