2N OfficeRoute - User manual, 1493 v1.9.0 User Manual
Page 82
82
Figure 3.68: GSM Routing - GSM
Click on the
item to display the routing rule adding rule
Add routing of GSM device
(Fig. 3.69).
Figure 3.69: GSM Routing - GSM Module Routing Rule
GSM device – Enter the GSM module number. The incoming calls through this
module will be assigned to the service specified in the
field.
Service name
Service name – Service through which the calls are to be routed into the VoIP
network.
Description – Any text describing the GSM routing rule meaning.
GSM Routing Normalising
The table normalises the calling (CLIP) numbers of the incoming calls from GSM
network.
The normalisation should be made to display the calling number on the IP telephone in
such manner, which enables proper routing of the back call into the
E
2N
®
VoiceBlue
nterprise gateway.
If, e.g., the gateway is configured to dial the calls into the GSM network by means of
prefix 0 and the incoming CLIP from GSM network starts with +420, the prefix +420
must be detached and replaced by 0 (see Fig. 3.70).
Example: