2N OfficeRoute - User manual, 1493 v1.9.0 - Manual (Page 64)

64
2N TELEKOMUNIKACE a.s., www.2n.cz
®
disabled for new SIM cards by default and has to be enabled if necessary.
Description – User description of the SIM card.
Service Centre Number – Enter the Service centre number. It is necessary for
SMS sending.
In order to use the SIM for data/Internet connection (for GPRS/EDGE/UMTS/HSPA - 2N
or GPRS - ), you have to set the
®
OfficeRoute 2N
®
VoiceBlue Enterprise
parameters. The other parameters depend on Connection provider name and APN
the network provider – for information refer to your network provider's websites or call
the provider's helpline.
Connection provider name – It can be any name. This field is compulsory.
Dial number (optional) – Number to be dialled for data connection.
APN (access point) – This field is compulsory. Complete it in accordance with
your provider´s APN name.
Initial AT commands (optional) – An optional field. You can define here a
special AT command for Internet connection.
PPP username (optional) – An optional field. Enter your PPP user name if
recommended.
PPP password (optional) – An optional field. Enter your PPP password if
recommended.
Don't replace default route – Tick off to leave the default gateway set to LAN
(Eth interface) after data connection is established. Change the setting with the
data connection off.
Don't use peer DNS – Define whether the DNS IP addresses should be
overwritten in compliance with the data connection provider after data
connection is established.
DISA Line
The DISA line can be a standard welcome note or a customised welcome note,
VoiceMail system and basic IVR. The DISA line is used for incoming calls, mostly from a
GSM network. It might also serve for incoming calls from the VoIP provider.
The DISA line plays a message/dial tone and then waits for DTMF dialling. After
receiving a hash (#), it dials the collected digits via a predefined SIP line.
The initial screen of the DISA line configuration shows a table of defined lines.
Click on the pencil icon to move to the line setting detail for changes. The symbo
l serves for line clearing.
Below the table there is an Add DISA service line icon. Click on it to display the
line defining form. There are also Upload custom DISA messages , Upload
DISA/IVR package to internal Flash and Upload VoiceMail language pack ic
ons.