2N BRI Lite/Enterprise v1.1 - Manual (Page 49)

49
4.1 Ethernet Interface
The BRI gateway can be fully configured via the web interface at
http://IP_gateway_address . Make sure that a device equipped with a web browser
(PC, NB, Tablet, etc.) has been connected for successful connection to the BRI
gateway configuration interface. The device also supports configuration via an
extended AT command set on the Telnet interface (IP port 23).
Tip
 The device also supports configuration via an extended AT command set
on the Telnet interface (IP port 23). Refer to Subs. 6, page 81 for details.
The BRI gateway supports DHCP (client). By default, the DHCP support is disabled.
Tip
 If DHCP is active, use specialised detection software (for LANs only) to
identify the assigned IP address. Refer to the www.2n.cz web sites, BRI
Gateways (IP Scanner) for the software.
Use the web configuration interface in the Gateway configuration - Ethernet
configuration section to set the Ethernet interface.
Ethernet Interface Factory Settings
IPv4 address 192.168.1.2
IP mask 255.255.255.0
User name Admin
User password 2n
Caution
 Change the user name and password during your first gateway
configuration to avoid unauthorised access to your gateway configuration!
Refer to page 78 for details!
Tip
 In the event of data loss or configuration interface unavailability, perform
the factory reset to retrieve the data. Doing so, however, you reset all the
default values in your gateway. Refer to Subs. 4.4, p. 53for details.