2N BRI Lite/Enterprise v1.1 - Manual (Page 54)

54
4.5 Basic Configuration
– Step by Step
This subsection helps you put your BRI gateway in operation for the first time. Refer
to the paragraphs of S. 3 for more detailed settings.
 Install the GSM gateway as instructed in Subs. 2.2. Remove the SIM cards or
insert the PIN-disabled SIM cards before the first launch.
 Connect the GSM gateway to the Ethernet to be able to get connected to the
address mentioned in Subs. 4.1, page 49 from the web interface. If the
default IP address of your gateway is not suitable for your Ethernet
installation, change the IP address setting as follows:
o Disconnect the configuration terminal from the Ethernet.
o Disconnect the GSM gateway from the Ethernet.
o Get an Ethernet switch or an Ethernet crossed cable.
o With the crossed cable, interconnect the configuration terminal directly
with the GSM gateway.
o With the Ethernet switch, connect the configuration terminal and GSM
gateway to the switch. We do not recommend you to connect any other
device.
o Change the IPv4 setting in your configuration terminal Ethernet settings
to, e.g.: IP=192.168.1.200, Net mask: 255.255.255.0
o Open your web browser and enter the IP address of your GSM gateway.
o Complete the factory login data.
o Change the required settings in the Gateway configuration - Ethernet
configuration section and save the changes into the GSM gateway.
o Connect the GSM gateway to a standard Ethernet.
o Rechange the IP settings of the configuration terminal and reconnect
the terminal to a standard Ethernet.
 Enter the new IP address of your GSM gateway to get connected to the web
interface.
 Set the current time and date for the GSM gateway in the Gateway control -
Date/Time menu.
 Check the Licence status for „unlocked‟ in the Gateway control -
Firmware/Licence menu. If the status is not unlocked, your GSM gateway is
not equipped with the proper licence (refer to page 60). Contact your dealer
for the licence key.
 Set the correct PIN code value in the Gateway configuration - System
parameters menu to meet the PIN code of the SIM cards used.
 Set new login data in the Gateway configuration - Login configuration menu.
 Switch off the GSM gateway and insert the SIM cards. Connect the antenna to
the GSM gateway and switch the gateway on.
 The GSM gateway factory configuration allows you to make outgoing calls
without any additional programming. All you have to do is set the correct
values for the BRI ISDN and VoIP interfaces.