2N BRI Lite/Enterprise v1.1 - Manual (Page 76)

76
Basic settings
 GSM network ID – set the prefix list user code for easier orientation in the
LCR.
 Default count of digits – default length of the number to be dialled into the
GSM/UMTS networks for routing via the selected prefix list. Use this
parameter in case the Digits count is not included in the Accepted prefixes
table.
Table of replaced prefixes
Use this table to replace the prefix of the received number („00‟ with „+‟, e.g.).
You can only add or remove the prefix. This change is made before the prefix is
searched for in the prefix table. Be sure to keep the „/“ record in the table for a
proper function.
Table of accepted prefixes
List of prefixes of called destinations to which the selected prefix list applies.
LCR table
The Least Cost Routing (LCR) table helps you route calls according to the called
party number, time and days in a week.
 Prefix list – prefixes to be used for a selected LCR row.
 Time limitation – time validity limitation for a selected LCR row.
 Weekend usage – enable/disable a row on weekends.
 Maximum length of call – set the maximum duration (minutes) for an
outgoing call to the GSM/UMTS network.
 Groups – outgoing GSM groups used for the selected LCR row.
 Tariffs – select the tariff group (free minute counter) to be used for the
outgoing call. Refer to the GSM outgoing groups subsection for details.
 Ignore tone detection in last group – having detected a user defined tone
(refer to GSM basic settings), the GSM gateway automatically terminates
the call and seeks for another call setup way. If this parameter is activated,
the GSM gateway ignores the tone detection results and sets up a call when
this is the only possible call establishing way.
Note
 If you use tariff routing, set the tariffs properly in the GSM outgoing
groups subsection