2N BRI Lite/Enterprise v1.1 - Manual (Page 91)

Status Messages 6.4
91
6.4 Status Messages
ISDN Layer 1 Message Status
ID
Name Description
0 DEACT Deactivation – no signal received
1 ACTIVE Activation – full synchronisation achieved (frame,multiframe,crc)
2 SIGNAL Signal received – no synchronization
3 SYNC Signal received – only partial synchronization (frame)
ISDN Layer 2 Message Status
ID
Name Name acc. to ITU-T Q.921
0 NOTEI TEI Unassigned
1 AWTEI Assigned Awaiting TEI
2 AWTEST Establish Awaiting TEI
3 OKTEI TEI Assigned
4 AWEST Awaiting Establishment
5 AWREL Awaiting Release
6 OKEST Multiple Frame Established
7 TIMREC Timer Recovery
ISDN Layer 3 Message Status
ID
Name Name acc. to Q.931 Description on NT interface Description on TE interface
0 NULL Null Rest status, ready for call
1 CINIT Call Initiated Call from BRI indicated Call to BRI started
2 OVSEND Overlap Sending Gradual dialling receiving Gradual dialling sending
3 OPROC Outgoing Call Proceeding Dialling from BRI terminated Dialling to BRI terminated
4 CDELIV Call Delivered Call from BRI ringing Call to BRI ringing
6 CPRES Call Present Call to BRI started Call from BRI indicated
7 CRECV Call Received Call to BRI ringing Call from BRI ringing
8 CONREQ Connect Request Call to BRI answered Call from BRI answered
9 IPROC Incoming Call Proceeding Dialling to BRI terminated Dialling from BRI terminated
10 ACTIVE Active Connected call
11 DISREQ Disconnect Request End of call from BRI End of call to BRI
12 DISIND Disconnect Indication End of call to BRI End of call from BRI
19 RELREQ Release Request Channel release request
25 OVRECV Overlap Receiving Gradual dialling sending Gradual dialling receiving
61 RSTREQ Restart Request Channel restart request sent
62 RSTART Restart Channel restart request received
Management Message Status
ID
Name Description
0 INIT Initialization upon BRI reset
1 IDLE Activation – rest status, necessary for layers 2 and 3
2 DISC Deactivation
GSM Layer Statuses
GSM Layer 2 Message Status
ID Name
Description Follows
0 INIT GSM module initialization start PINREQ
1 SIM0 Module switch to internal SIM card INIT
2 PINREQ Module PIN request PINSET
3 PINSET PIN value sensing to module INFO
4 BLOCK Module blocked temporarily or permanently (see Layer 2 information) INIT
5 SETUP Module configuration running IDLE
6 SLEEP Module sleep running (transition to BLOCK status) BLOCK