AirLive RS-1000 - Manual (Page 107)

１０２
Modifying an Outgoing policy
Step 1.
In the Modify Policy window, fill in new settings.
Note: To change or add selections in the drop-down list for source or destination address,
go to the section where the selections are setup. (Source Address→LAN of Address menu;
Destination Address → WAN of Address menu; Service→[Pre-defined],[Custom] or
Group under Service).
Click OK to do confirm modification or click Cancel to cancel it.
Figure7-3 Modify the Outgoing Policy
Source Address: Select the name of LAN from the pull-down menu.
The names of LAN listed in this pull-down menu are: the Source Addresses that are already
set.
Destination Address: Select the name of WAN from the pull-down menu.
The names of WAN listed in this pull-down menu are: the Destination Addresses that are
already set IP address of WAN network.
Service: Select the service item from the pull-down menu
Action: Select Permit or Block to allow or reject the specified packets from LAN network to
WAN network.
Logging: Select Enable to enable the Logging function.
Statistics: Select Enable to enable the Statistics function.