AirLive RS-1000 User Manual
Page 111
１０６
fourth column is the Alarm Threshold function. The fifth column is the QoS function. If the
figures appear in the column, it means that the function is enabled. On the other hand, if there
is no figures appeared in the column, it means that the function is not enabled.
The fields of the Incoming window are
:
"
Source: source networks which are specified in the WAN section of the
Address menu, or all the WAN network addresses.
"
Destination: destination networks, which are IP Mapping addresses or
Virtual server network addresses created in Virtual Server menu.
"
Service: services supported by Virtual Servers (or Mapped IP).
"
Action: control actions to permit or deny packets from WAN networks to
Virtual Server/Mapped IP travelling through the device.
"
Option: specify the monitoring functions on packets from WAN networks to
Virtual Server/Mapped IP travelling through the Security Bandwidth Manager.
"
Configure: modify settings or remove incoming policy.
"
Move: this sets the priority of the policies, number 1 being the highest priority.
Descriptions for Policy figures:
Figure
Name
Description
Permit
Permit the specified packets from WAN to LAN.
Block
Block the specified packets from WAN network to
LAN network.
Log
Traffic and event log function is enabled.
Statistics
Flow statistics function is enabled.
Schedule
The automatic execution function in Schedule table
has been enabled.
Alarm
Threshold
Traffic and event alarm function is enabled.
QoS
QoS function is enabled.