AirLive RS-1000 - Manual (Page 115)

１１０
Modifying Incoming Policy
Step 1.
In the Modify Policy window, fill in new settings.
Step 2.
Click OK to save modifications or click Cancel to cancel modifications.
Figure7-7 Modify an Incoming Policy
Source Address：Select the name of WAN from the pull-down menu.
The names of WAN listed in this pull-down menu are：the Source Addresses that are already
set. If you want to add new WAN addresses to WAN of address menu, you have to go to WAN
function window to configure; you will not be able to add new WAN addresses here.
Destination Address：Select the name of LAN from the pull-down menu.
The names of LAN listed in this pull-down menu are：The Mapped IP or Server Virtual IP
configured in the Mapped IP or Virtual Server 1/2/3/4 window under Virtual Server function. To
add new items into the pull-down menu, go to Virtual Server window to configure.
Service：Select the service item from the pull-down menu.
Action：Select from the pull-down menu to determine the WAN, Virtual Server(or Mapped IP)
packets are permitted or forbidden to pass. Select Permit or Forbid.
Logging：Select Enable to enable the Logging function.
Statistics：Select Enable the enable the Statistics function.
Schedule：Select the item listed in the schedule to enable the policy to automatically execute
the function in a certain time and range.
Alarm Threshold：To set the maximum value of transmitting and receiving packet, enter the
number based on the unit（KBytes/Sec）