Atop Technology SE5002D User manual - Manual (Page 51)

Atop Serial Device Server
SE5002D
User Manual V. 1.1
 Check Enable Pair Connection to enable Pair Connection application in SE5002D.
 Scroll to the bottom of the page and click on “Save Configuration” button to save the
changes.
 Go to the Pair Connection Slave Setup , remember this SE5002D ’s IP address and the
Local Listening Port here in order to enter this information in the Pair Connection Slave
later.
3.5.4 Enable Reverse Telnet
Reverse Telnet application is a useful telnet program used to connect to SE5002D and the
SE5002D ’s serial interface when connected to a Terminal Server. Telnet programs in
Windows/Linux usually require special handshaking to get the outputs and formatting show
properly. SE5002D will interact with those special commands (CR/LF commands) if Reverse
Telnet is enabled.
Fig. 3. 29
 Follow Sec. 3.2.5 to configure SE5002D in TCP Server mode properly.
 Check Enable Pair Connection to enable the Pair Connection application in SE5002D.
 Scroll to the bottom of the page and click on “Save Configuration” button to save the
changes.