Atop Technology SE5002D User manual - Manual (Page 56)

Atop Serial Device Server
SE5002D
User Manual V. 1.1
3.6.2 Enable RFC 2217
The underlying protocol of Virtual COM is based on RFC 2217, the Telnet COM Control Option.
Therefore, it is possible to use RFC 2217 with SE5002D in the TCP Client mode. To do so,
refer to Sec. 3.6 to enable Virtual COM, so that SE5002D becomes aware of the commands.
Note that there is no need to configure Virtual COM on the OS because Virtual COM ports will
not be used.
3.6.3 SE5002D as a Pair Connection Slave
A Pair Connection Slave ( Fig. 3. 33 ) needs to pair up with a Pair Connection Master. Please
make sure you already have a Pair Connection Master setup before proceeding.
Fig. 3. 33