Attention – CHAMPION USN72 User Manual
Page 185
1
1-7/8"
48mm
Backsplash
Dish Table
WALL
3765 Champion Boulevard
Winston-Salem, NC 27105
Toll-free:
1 (800) 858-4477
Fax:
(336) 661-1660
Table Limit Switch (TLS) Installation Instructions
for Service Kit P/N 418404
Form No. 900948_v10110
NOTE:
These instructions pertain to USN72 Rack Conveyor Dishwashers.
I
ntroduction:
A table limit switch (TLS) should be installed on the dishwasher unload dish table to prevent
dishwasher conveyor jams if dish racks accumulate as they exit the dishwasher. The TLS
shuts down the dishwasher conveyor drive until dish racks are removed.
! ATTENTION !
This Kit will not work if the distance between the backsplash and the wall is less than 1-7/8" [48mm].
See Section 1: Checking Wall Clearance before beginning the TLS installation.
Fig. 1 -
Check wall to backsplash clearance
Section 1: Check Wall Clearance
Before beginning the installation, measure the distance from the wall to the dish table
backsplash. The minimum clearance is 1-7/8" [48mm]. See Fig. 1 below.
This kit will not work if the proper clearance is unavailable.