CHAMPION USN72 - Manual (Page 20)

Part 1: GENERAL SPECIFICATIONS
2
1.3 Standard Equipment
♦ Modular construction for easy installation
♦ Deep tank design to withstand 15 ° list without water slosh
♦ Heavy duty dual chain drive with rear lugs
♦ Lift-out doors
♦ Open construction without panels for easy service and cleaning
♦ Exhaust vent extended to table level on each end
♦ All 304 stainless steel construction
♦ Flanged feet for deck mounting
♦ Interchangeable upper and lower spray arms
♦ 2 HP drip proof pump/motor assemblies
♦ 1/4 HP conveyor drive motor
♦ Make up water with constant flow during operation
♦ Dishwasher shutdown below 180 ° F final rinse temperature via thermal switch
♦ Manual fill for wash/rinse tank with water level sight gauges
♦ Manual Ball valve drain in each tank plumbed to a common connection
♦ Steam piping without threaded joints in tanks
♦ Remote mounted NEMA 4X control cabinet
♦ Common utility connections
♦ 440/60/3 power supply
♦ 120VAC control circuit
♦ Steam coil or electric tank heat
♦ Detergent/Chemical connection provisions
♦ Float switch low water heat protection with 5 second delay
♦ Door safety switches
♦ Conveyor jam limit switch
♦ Easily removable scrap screens
♦ Rinse saver device for water conservation
♦ Dishracks (peg rack and flat bottom rack)
Options and Accessories
♦ External steam booster heater 40 ° or 70 ° rise (specified at time of order)
♦ External electric booster heater 40 ° or 70 ° rise (specified at time of order)
(stainless steel, completely interplumbed and interwired)
♦ Right to left or left to right conveyor operation (specified at time of order)
♦ Choice of conveyor speed (250, 185, 135, 85, or 60 racks per hour)
(specified at time of order)
♦ Power unloader
♦ 90 ° motorized rack advance conveyor (specify load or unload)
♦ Dishracks - dish or open (specify type)
♦ Table limit switch, unmounted (recommended on all conveyor installations)