CHAMPION USN72 User Manual
Page 187
3
Table Limit Switch (TLS) Installation Instructions
Section 3: Drilling and Cutting the Dish Table
1. Refer to Fig. 2, Paper Drilling Template, below.
2. Fold the paper template, included in the kit, along the dotted line and place the template
on the inside bottom end of the dish table with the printed side visible.
3. Mark and drill the holes according to the direction of operation for your dishwasher
( L to R or R to L dishwasher operation). See Fig. 3, TLS Orientation, below.
4. Mark and cut a 7/8" hole using a knock-out punch in the appropriate location.
DRILL (2) 3/16" DIA. HOLES
BOTTOM EDGE OF TABLE
6"
6"
FOR R-L OPERATION
FROM INSIDE END OF TABLE
FOR L-R OPERATION
FROM INSIDE END OF TABLE
END OF TABLE
END OF TABLE
7
8
115
16
1 3
16
134
Fig. 2 -
Paper Drilling Template
TLS
TLS
Left to Right Operation
Right to Left Operation
Dishwasher
Dish Table
Dish Table
Dishwasher
Rinse Tank
Rinse Tank
Wash Tank
Wash Tank
Fig. 3 -
TLS Orientation
(Drawing Not to Scale)