CHAMPION USN72 - Manual (Page 23)

NOTE:
If you need to move the dishwasher through shipboard hatches, refer to Part 2.2,
Disassembly, on the next page.
5
PART 2: INSTALLATION
In This Part—
• Unpacking the dishwasher
• Disassembling the dishwasher to move through hatches
• Making Utility Connections
2.1 Unpack the Dishwasher
NOTE:
The installation of your dishwasher must meet all applicable
health and safety codes and conform to good trade practice.
Your USN-72 was completely assembled, inspected, and thoroughly tested at our factory
before shipment to your installation site.
• The dishwasher with vents and booster are shipped on a single pallet.
• The booster is disconnected from the dishwasher.
• The remote mounted control cabinet is shipped in a separate carton.
Perform the following steps to unpack the dishwasher:
1. Remove protective wrap and hold-downs from the pallet.
2. Inspect for any shipping damage. If damage is found, save the packing material
and contact the carrier immediately.
3. Check the interior of the dishwasher for the following items stowed inside:
- 1 set of flanged feet
- 1 set of dishracks
- Warranty information packet
CAUTION:
Check piping mounted underneath dishwasher before lifting, to avoid damaging the
machine.
4. Remove the dishwasher from the skid.
5. Move the dishwasher to its permanent location if no disassembly is
required. Refer to Part 2.4, Permanent Placement.
Part 2: INSTALLATION
!