HMC Electronics MDL Series BK Precision DC Electronic Load System Module - Manual (Page 22)

22
Installing Modules
CAUTION : Static electricity may damage load modules. Please install modules
according to standard electrostatic prevention. Avoid touching joints and circuit
boards.
One can install any combination of modules up to 2400 W total in the MDL001 mainframe in any
order. This also applies to the MDL002 mainframe extension, allowing a maximum of 4800 W total
when connecting the MDL001 and MDL002 together. The procedure of installing modules to the
mainframe extension is the same as that of the MDL001 mainframe.
Installation Procedure
1.
Turn the mainframe off and disconnect the power cord.
2.
Loosen screws on front panel plastic cover and remove from mainframe.
Figure 3a - Module Installation
3.
Remove plastic cover on rear with flat-blade screwdriver.
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
http://www.hmcelectronics.com
(800) 482-4440