Toggle, Setting up a/b transient operation – HMC Electronics MDL Series BK Precision DC Electronic Load System Module User Manual
Page 52
52
Toggle
In toggle mode, the electronic load will switch between A level and B level when receiving a trigger
signal after the transient operation is enabled. The following picture shows the current waveform
in toggle transient operation.
Figure 27 - Toggle Transient Operation
Setting Up A/B Transient Operation
The following is a short tutorial of how to set up A/B transient operation for your electronic load.
In this example, we will set up rise speed at 1 A/us and fall speed at 2 A/us. The electronic load will
be in continuous transient mode and switch between 10 A and 2 A in durations of 0.002 s and
0.003 s respectively.
Note : When setting up steps, make sure all transient level, slew, and width parameters are
within the modules’ specified limits.
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440