HMC Electronics MDL Series BK Precision DC Electronic Load System Module - Manual (Page 66)

66
3.
Press Setup key to enter the channel setup menu, press Enter
key to enter the <Mode> selection menu and press  key to
select the operating mode. Every step’s mode can be edited.
Press Enter key to confirm.
MODE= CC
RANGE= HIGH
Iset= 1.00A
4.
Press  key to select <ISet>. Press Enter to enter the menu and
set the working current. For example, to set 1A, press ① and
then Enter to confirm.
Const Current
Set= 1.000A
5.
Press  key to move the cursor to Vmax=82.000V and press
Enter to set the upper limit of testing voltage. In this example,
the first step is 5.8V. Press ⑤  ⑧ and then Enter to confirm.
Voltage Upper
Limit= 5.800V
6.
Press  key to move the cursor to Vmin=0.000V and press Enter
to set the lower limit of testing voltage. In this example, the first
step is 0.15V. Press  ① ⑤ and then Enter to confirm.
Voltage Lower
Limit= 0.150V
7.
After editing the first step of channel 3, press Esc key to exit the
menu.
8.
Press  keys to select channel 5. To edit the first step of
channel 5, repeat steps 3 through 6 with desired parameters.
CH05 CC OFF
Vdc=0.0000V
Adc=0.0000A
Wdc=0.00W
9.
After editing the first step of channel 5, press Esc key to exit the
menu.
10.
Save the edited first step of channel 3 and channel 5. Press Save
and ① to save step 1. Press Enter to confirm.
Save Group
1
11.
In the same manner, you can edit the rest of the steps for
channel 3 and channel 5 by repeating steps 2 through 10 above.
These saved groups correspond to sequences that will be
selected in your program below.
12.
Press Shift + ⑨ key to enter the Program menu. Press  key to
select <Edit Program> and press Enter.
Run Program
Recall Prog
Edit Program
Exit
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
http://www.hmcelectronics.com
(800) 482-4440