4 monitor cover removal – INFICON TM-400 Thin Film Deposition Monitor User Manual
Page 42
4 - 8
IP
N 17
88
0
0 Re
v.
B
TM-350/400 Operating Manual
4.4 Monitor Cover Removal
WARNING - Risk Of Electric Shock
Under no circumstances should the Monitor cover be
removed without first removing the line voltage cord, as
dangerous voltages are present inside the case.
CAUTION - Static Sensitive Device
To prevent damage to internal components by means of
electrostatic discharge (ESD), wear a grounded
anti-static wrist strap.
Five screws located on the top of the instrument and 1 screw on the rear panel
secures the cover of the Monitor. Remove the 6 screws, and slide the top cover
toward the rear.
To reinstall the cover, slide it into the groove created by the front and side panels,
then replace the screws.
WARNING - Risk Of Electric Shock
To avoid electrical shock or personal injury, do not
operate the monitor without its cover installed in place.