JUMO 709062 TYA 202 - Three-Phase Power Controller Operating Manual - Manual (Page 59)

2012-12-31/00561073 [SCR power switch TYA202] 57
5 Configuration
Base load 0 to U
nom
of the load voltage,
0 to P
nom
of the power
0 to I
nom.
of the max. load cur-
rent
0 to 100 %
of the output level
Note:
This setting is only available if power controller
r
SCR control
r
Continuous (power controller) is set.
The unit depends on the setting for subordinate control loop
and device type:
- For voltage: 0 to 100 % of the max. load voltage (e.g. 0 V)
- For current: 0 to 100 % of the max. load current (e.g. 0 A)
- For power: 0 to 100 % of the power (e.g. 0 W)
- None: 0 to 100 % of the output level (e.g. 0 %)
The measured values in the master branch are measured.
v Chapter 1.3 "Order details"
k / bold = factory setting
Control signal
P
Base load: 680 W
Maximum
Output level: 3680 W
0 mA 20 mA
3000W 0...20mA
־
Base load