JUMO 709062 TYA 202 - Three-Phase Power Controller Operating Manual - Manual (Page 73)

2012-12-31/00561073 [SCR power switch TYA202] 71
6 Special device functions
If the Teach-In is being performed for the first time, the message "Teach In
load monitoring" appears in the bottom line of the display.
6.2.3 Performing Teach-In in manual mode
The power controller is in the "Measured value overview" level.
h Press the
key twice to return to manual mode.
If the Teach-In is being performed for the first time, the message "Teach In
load monitoring" now appears in the bottom line of the display.
h Press the
key and the following message will appear:
h Press the
key to apply the current load state as the OK status.
A change in the load (load error) will be evaluated by the device on the basis of
this status.
Repeating
teach-in The Teach-In can be repeated any number of times in manual mode.
h Press the
key and the following message will appear:
h Press the
key to apply the current load state as the OK status.