JUMO 709061 TYA 201 - Single-Phase Power Controller Operating Manual - Manual (Page 106)

104 2012-12-01/00561071 [SCR Power Controller TYA201]
9 What to do, if ...
Power controller is not
producing full power
even though the setpoint
value is set to 100 % - Current limiting active
h Check settings
v See "Current lim-
iting" on page 57.
- Half-wave control set
(half power)
h Change to burst-firing mode or phase an-
gle control
v See "Operating
mode" on
page 53.
What is happening? Cause/remedy Information