4 operation – JUMO 709061 TYA 201 - Single-Phase Power Controller Operating Manual User Manual
Page 51
Advertising
2012-12-01/00561071 [SCR Power Controller TYA201]
49
4 Operation
This function is not configured ex works.
This window only appears if the following setting has been
made in the configuration level:
h Press the
key to switch to the configuration level
h Set Monitoring
r
Teach-in type load monit.
r
Manual
h Press the
key
The "Manual teach-in" function is now configured.
h Change to the operator level
r
Monitoring
r
Load monit.
teach-in
h Press the
key
A screen now appears asking whether the state should be ap-
plied now. If so:
h Press the
key to apply the current load state as the OK
status.
A change in the load (load error) will be evaluated by the device
on the basis of this status.
k
/ bold = factory setting
Advertising