5 commissioning the device – JUMO 701150 14597 safetyM STB/STW - Safety Temperature Limiter and Safety Temperature Monitor Operating Manual User Manual
Page 29
5 Commissioning the device
29
5.3
Selecting and editing parameters (plausibility inquiry for input values)
The values are displayed in the standard display.
Carry out steps 1 to 4 to edit a value, e.g. in this case, the limit value
1
Press
The first menu item "Analog inputs" has a black
background. The vertical line on the right shows
the current position.
2
Select limiter/monitor with
Use
to change to the submenu
3
Press
2x until the limit value appears
Press
(limit value flashes)
4
Use
or
to set the desired value
Acknowledge with
(limit value is shown in duplicate)
Limit value flashes in du-
plicate on the display as a
control.
5
Briefly press
to confirm the value.
The value is applied and saved.
Use
+
to return to the standard display
or menu topic "Back" or
return automatically after a timeout
H
If no key is pressed, the device automatically returns to the standard display after 30 seconds (timeout) and the value
is not saved. The length of the timeout is configurable.
v
see operating overview on the first inner page of this manual.