JUMO 701150 14597 safetyM STB/STW - Safety Temperature Limiter and Safety Temperature Monitor Operating Manual - Manual (Page 82)

7 Configuration level 2014-05-01 82
7.5 Analog output
Parameter Comment
Value range
(factory-setting in bold)
7.5.1 Function Here, the measured value that is to be shown at the
analog output is set.
Main measured value
Measured value1
Measured value2
Difference Main measured value:
With the max-alarm switching behavior, the greater of
the two measured values is shown; with the min-alarm,
the lower of the two measured values is shown.
Measured value1:
Measured value of analog input 1 (E1) is shown
Measured value2:
Measured value of analog input 2 (E2) is shown
Difference:
E1-E2 is shown
The signal that should be output by the analog output
can be set with scaling start and end.
7.5.2 Signal type 4 to 20 mA 4 to 20 mA,
0 to 20 mA
2 to 10 V
0 to 10 V
0 to 20 mA
2 to 10 V
0 to 10 V
7.5.3 Scaling start v Picture in Chapter 7.5.6 -9999 to -200 to 9999
7.5.4 Scaling end v Picture in Chapter 7.5.6 -9999 to 800 to 9999