Setting up the instrument – Leica Biosystems CM1520 User Manual
Page 18
Advertising
18
Instructions for Use V1.3 – 10/2012
4.
Setting up the instrument
• Lift and remove the wooden edge (6).
• Remove the ramp (5) on the front side of the
pallet (see Fig. 6) and correctly attach it to
the back (see Fig. 8).
6
Fig. 7
Fig. 8
5
5
• Carefully roll the instrument backwards over the ramp from the pallet.
• Push the instrument to the installation location on the castors (7).
7
8
Transport
grip points
Do not push the device by its hood (8)!
Use the transport grip points ( , Fig. 8).
The rollers (7) must run over the ramp (5) at the front and rear. Danger of tipping!
The instrument must be transported in an upright position.
Advertising