Leica Biosystems CM1520 - Manual (Page 21)

21 Leica CM1520 – Cryostat
4.4 Assembling the handwheel
To install the handwheel, follow these steps:
• Insert the pin (1) of the handwheel shaft into the hole (2) of the handwheel.
• Attach the spring washer (3) to the screw (4) as shown in Fig. 10.
• Tighten the screw (4) using an Allen key (6 mm).
• Attach the cover disk (self-adhesive - not pictured).
To dismount, proceed in reverse order.
4. Setting up the Instrument
1
2
4
Fig. 10
3
4
The handwheel and all parts for installation are included in the carton with the accessories.
The handwheel can be dismounted for transporting (e.g. narrow doors).
Rotate the handwheel only if the refrigeration system is on and the cryochamber is cold.