Lenze MDSLS Servo spindle motor - Manual (Page 3)

BA 33.0003 1.0 04/2004 TD09
 2004
Nameplate of servo spindle motor
1
2
6
13
12 9
4 5
3 17
18
16
21
22
15
8 7 14
23 22 21 mm FN / kN
19
No. Explanation No. Explanation
1 Motor type: three-phase AC motor 13 Rated voltage U
N
[V]
2 Lenze motor type 14 Rated torque M
N
[Nm]
3 ID no. 15 Labelling of thermal detector
4 Enclosure 16 Data for holding brake: voltage, current, torque
5 Thermal class 17 Labelling of encoder 1)
6 Rated current I
N
[A] 18 Motor no.
7 Rated frequency f
N
[Hz] 19
Selection number for operation at servo inverters of
series 9300 2)
8 Rated speed n
N
[min-1] 21 Rated load
9 Continuous standstill torque M
0
[Nm] 22 Lead
12 Rated power P
N
[kW] 23 Lift
1) RS1 - Lenze-specific resolver (1 pair of poles)
RS3 - KUKA-specific resolver (3 pairs of poles)
2) For operation with servo inverters of series 9300:
In C0086 or GDC (Global Drive Control software), enter the specified selection number to automatically optimise the control mode.
What is new / what has changed in the Operating Instructions?
Material number Edition Important Contents
00 492 660 1.0 04/04 TD09 1st edition First printing
© 2004 Lenze Drive Systems GmbH, Hans-Lenze-Straße 1, 31855 Aerzen
No part of this documentation may be reproduced or made accessible to third parties without written consent by Lenze Drive
Systems GmbH.
All information given in this documentation has been selected carefully and complies with the hardware and software
described. Nevertheless, deviations cannot be ruled out. We do not take any responsibility or liability for damages which might
possibly occur. Necessary corrections will be included in subsequent editions.
Show/Hide Bookmarks