Lenze EMZ9371BC - Manual (Page 91)

Parameterisation 8200 vector/8200 motec
Menu structure
7
EDK9371BC DE/EN/FR 3.1 91
l
H1 Parametrierung 8200−9371BC_6L
Description Submenus Main menu Description
Display No. Display No.
5.2 Speed−Ctrl 1 Frequency setpoint via parameter
channel (C0046)
Digital selection of frequency
setpoint via frequency input (DFIN)
5.2.1 Freq setpt Frequency setpoint configuration
5.2.2 Actual value Actual frequency value configuration
5.2.3 PCTRL setup Process controller configuration
5.2.4 f limit/ramp Output frequency, acceleration time
and deceleration time configuration
5.2.5 Motor param Motor current control and motor
monitoring configuration
5.3 Speed−Ctrl 3 Frequency setpoint via AIF process
data channel (AIF−IN.W1)
Digital selection of frequency
setpoint via frequency input (DFIN)
5.3.1 Freq setpt Frequency setpoint configuration
5.3.2 Actual value Actual frequency value configuration
5.3.3 PCTRL setup Process controller configuration
5.3.4 f limit/ramp Output frequency, acceleration time
and deceleration time configuration
5.3.5 Motor param Motor current control and motor
monitoring configuration
5.4 Speed−Ctrl 5 Operation with the system bus (CAN)
function module on FIF
Frequency setpoint via process data
channel (CAN−IN1.W2)
Actual frequency value via process
data channel (CAN−IN1.W3)
5.4.1 CAN managem Set up system bus (CAN)
communication
5.4.2 Freq setpt Frequency setpoint configuration
5.4.3 Actual value Actual frequency value configuration
5.4.4 PCTRL setup Process controller configuration
5.4.5 f limit/ramp Output frequency, acceleration time
and deceleration time configuration
5.4.6 Motor param Motor current control and motor
monitoring configuration