Lenze EMZ9371BC - Manual (Page 98)

7 Parameterisation 8200 vector/8200 motec
Menu structure
EDK9371BC DE/EN/FR 3.1 98
l
H1 Parametrierung 8200−9371BC_6L
Description Submenus Main menu Description
Display No. Display No.
5.24 PID−Ctrl 2 Analog setpoint selection via analog
input 1 (AIN1)
Analog selection of actual value via
analog input 2 (AIN2)
5.24.1 Setpoint Setpoint configuration
5.24.2 Actual value Actual value configuration
5.24.3 PCTRL setup Process controller configuration
5.24.4 f limit/ramp Output frequency, acceleration time
and deceleration time configuration
5.24.5 Motor param Motor current control and motor
monitoring configuration
5.25 PID−Ctrl 3 Setpoint via AIF process data channel
(AIF−IN.W1)
Analog selection of actual value via
analog input 1 (AIN1)
5.25.1 Setpoint Setpoint configuration
5.25.2 Actual value Actual value configuration
5.25.3 PCTRL setup Process controller configuration
5.25.4 f limit/ramp Output frequency, acceleration time
and deceleration time configuration
5.25.5 Motor param Motor current control and motor
monitoring configuration
5.26 PID−Ctrl 5 Operation with the system bus (CAN)
function module on FIF
Setpoint via process data channel
(CAN−IN1.W2)
Actual value via process data channel
(CAN−IN1.W3)
5.26.1 CAN managem Set up system bus (CAN)
communication
5.26.2 Setpoint Setpoint configuration
5.26.3 Actual value Actual value configuration
5.26.4 PCTRL setup Process controller configuration
5.26.5 f limit/ramp Output frequency, acceleration time
and deceleration time configuration
5.26.6 Motor param Motor current control and motor
monitoring configuration