Lenze EMZ9371BC - Manual (Page 97)

Parameterisation 8200 vector/8200 motec
Menu structure
7
EDK9371BC DE/EN/FR 3.1 97
l
H1 Parametrierung 8200−9371BC_6L
Description Submenus Main menu Description
Display No. Display No.
5.21 Torque−Ctrl 7 Operation with the fieldbus function
module on FIF (DRIVECOM control)
Torque setpoint via process data
channel
Speed limitation via process data
channel
5.21.1 FIF managem Set up fieldbus communication
5.21.2 Torque setpt Torque setpoint configuration
5.21.3 f limit Speed limitation configuration
5.21.4 Motor param Motor current control and motor
monitoring configuration
5.21.5 Motor ident Motor parameter identification
Process control with PID controller in the "V/f characteristic control"
operating mode
5.22 PID−Ctrl 0 Setpoint via parameter channel
(C0181)
Analog selection of actual value via
analog input 1 (AIN1)
5.22.1 Setpoint Setpoint configuration
5.22.2 Actual value Actual value configuration
5.22.3 PCTRL setup Process controller configuration
5.22.4 f limit/ramp Output frequency, acceleration time
and deceleration time configuration
5.22.5 Motor param Motor current control and motor
monitoring configuration
5.23 PID−Ctrl 1 Setpoint via parameter channel
(C0138)
Analog selection of actual value via
analog input 1 (AIN1)
5.23.1 Setpoint Setpoint configuration
5.23.2 Actual value Actual value configuration
5.23.3 PCTRL setup Process controller configuration
5.23.4 f limit/ramp Output frequency, acceleration time
and deceleration time configuration
5.23.5 Motor param Motor current control and motor
monitoring configuration