Lenze DDS Target 9300 Servo PLC V8.x - Manual (Page 142)

3.6 Code table
9300 Servo PLC
Appendix
3−136
L
9300 Servo PLC EN 5.1
Code Information Possible settings LCD Code Information
Selection Lenze
LCD
C0383 LifeTimeFact. 0 System bus: Node guarding (slave): NodeLifeTime factor
Factor for the NodeLifeTime monitoring time:
NodeLifeTime = C0383 x C0382 (NodeGuardTime)
·
Only relevant for setting C0352 = 4.
·
Additional information about the "node guarding"
function can be found in the Manual for the function
library LenzeCanDSxDrv.lib.
0 {1} 255
C0384 Err NodeGuard 3 System bus: Node guarding (slave):
Response to a "node guarding" event.
·
Only relevant for setting C0352 = 4.
·
Additional information about the "node guarding"
function can be found in the Manual for the function
library LenzeCanDSxDrv.lib.
0 TRIP
1 Message
2 Warning
3 Off
4 FAIL−QSP
C0400 DIS: OUT
g
Analog input terminal 1/2 (AIN1_nIn_a)
−199.99 {0.01 %} 199.99
C0405 DIS: OUT g Analog input terminal 3/4 (AIN2_nIn_a)
−199.99 {0.01 %} 199.99
[C0416] Resolver adj 0 Correction of the resolver error
·
For Lenze motors:
Read resolver error from the nameplate
0 {1} 99999999
[C0420] Encoder const 512 Encoder: Constant for encoder input X8
1 {1 inc/rev} 8192
[C0421] Enc voltage 5.00 Encoder: Supply voltage for the encoder
·
CAUTION: Incorrect input may destroy the encoder
5.00 {0.1 V} 8.00
C0425 DFIN const 3 Digital frequency input DFIN_IO_DigitalFrequency:
Increments of the encoder input
0 256 increments per revolution
1 512 increments per revolution
2 1024 increments per revolution
3 2048 increments per revolution
4 4096 increments per revolution
5 8192 increments per revolution
6 16384 increments per revolution
C0426 DIS: OUT g Digital frequency input DFIN_IO_DigitalFrequency:
DFIN_nIn_v
−32767 {1 rpm} 32767
C0427 DFIN function 0 Digital frequency input DFIN_IO_DigitalFrequency:
Type of the digital frequency signal
0 2 phases
1 A = Speed / B = Direction
2 A or B = Speed or direction
C0428 DFIN TP sel. 0 Digital frequency input DFIN_IO_DigitalFrequency:
Touch probe selection
0 Touch probe via zero pulse
1 Touch probe through digital input X5/E5
C0429 TP delay 0 Digital frequency input DFIN_IO_DigitalFrequency:
Touch probe delay
·
Compensation of delay times of the TP signal source at
X5/E5
−32767 {1 inc} 32767