Outputs_aif2, 9300 servo plc, System blocks – Lenze DDS Target 9300 Servo PLC V8.x User Manual
Page 23: 2 outputs_aif2, 2 aif2_io_automationinterface (node number 42)
9300 Servo PLC
System blocks
2.2
AIF2_IO_AutomationInterface (node number 42)
2−17
L
9300 Servo PLC EN 5.1
2.2.2
Outputs_AIF2
This SB is used as an interface for output signals (e.g. setpoints/actual values) to attached fieldbus
modules (e.g. INTERBUS, PROFIBUS−DP).
·
The process image is
– created in the cyclic task in a fixed time interval of 10 ms.
– created in an interval task within the time set for this task.
– read at the beginning of the task and written at its end.
Tip!
Please observe the Operating Instructions for the attached fieldbus module.
Outputs_AIF2
Automation
Interface
...
Byte
1
Byte
2
Byte
3
Byte
4
Byte
5
Byte
6
Byte
7
Byte
8
...
16 Bit
LowWord
16 Bit
HighWord
16 Bit
16 binary
signals
16 Bit
16 binary
signals
AIF2_nOutW2_a
AIF2_nOutW1_a
AIF2_bFDO0_b
AIF2_bFDO15_b
AIF2_bFDO16_b
AIF2_bFDO31_b
16 Bit
16 Bit
AIF2_nOutW4_a
AIF2_dnOutD1_p
AIF2_nOutW3_a
Fig. 2−4
Outputs_AIF2