Interface, 2 p2 - ethernet communications port, Ethernet 1 8 – Lenze E94P PositionServo with MVOB User Manual
Page 23
S94H201E_13426446_EN
L
21
Interface
All conductors must be enclosed in one shield with a jacket around them. The shield on the drive end of the
motor power cable should be terminated to the conductive machine panel using screen clamps as shown in
section 3.2. The other end should be properly terminated at the motor shield. Feedback cable shields should
be terminated in a like manner. Lenze recommends Lenze cables for both the motor power and feedback.
These are available with appropriate connectors and in various lengths. Contact your Lenze representative
for assistance.
Wire Size
Current
A (rms)
Terminal
Torque (lb-in)
Wire Size
I<8
4.5
16 AWG (1.5mm
2
) or 14 AWG (2.5mm
2
)
8<I<12
4.5
14 AWG (2.5mm
2
) or 12 AWG (4.0mm
2
)
12<I<15
4.5
12 AWG (4.0mm
2
)
15<I<20
5.0 - 7.0
10 AWG (6.0mm
2
)
20<I<24
11.0 - 15.0
10 AWG (6.0mm
2
)
4.1.2
P2 - Ethernet Communications Port
P2 is a RJ45 Standard Ethernet connector that is used to communicate with a host computer via Ethernet
TCP/IP.
P2 Pin Assignments (Communications)
Pin
Name
Function
ETHERNET
1
8
P2
1
+ TX
Transmit Port (+) Data Terminal
2
- TX
Transmit Port (-) Data Terminal
3
+ RX
Receive Port (+) Data Terminal
4
N.C.
5
N.C.
6
- RX
Receive Port (-) Data Terminal
7
N.C.
8
N.C.
NOTE
To communicate from the PC directly to the drive a crossover cable is recommended. If
using a hub or switch, use a regular patch cable.