Lenze E94P PositionServo with MVOB - Manual (Page 41)

S94H201E_13426446_EN L 39
Parameters
5.1 Drive Identification
At the top of the Node Tree, click the Drive name [E94P 240V 04Amp ...]. The drive ID string, device
family, firmware revision, vector processor revision, hardware revision, MotionView OnBoard revision, motor
database revision, indexer compiler revision, serial number, drive name and group ID are displayed as
illustrated herein. With the exception of the Drive Name and Group ID, the drive identification parameters
are fixed and provided for information only.
The drive identifier (E94P 240V 04Amp [192.168.124.120] : STOPPED) in the node tree consists of three
segments: the drive’s name, the drive’s IP address and the status of the Indexer Program.
Drive name: E94P 240V 04Amp
Drive IP address: 192.168.124.120
Indexer program status: STOPPED (indexer program is stopped)
RUNNING (indexer program is running)
The drive identifier also indicates the status of the drive. When the drive identifier in the node tree is
highlighted in green, the drive is enabled. When the drive identifier is gray, the drive is disabled.
5.1.1 Drive Name
To assign a name to the drive click in the box adjacent to Drive Name. A alpha-numeric name may be
entered to identify the drive.
5.1.2 Group ID
The Group ID feature allows the user to group PositionServo drives together via an Ethernet network. When
used with the SEND and SENDTO command, drives in the same group can share and update variables. Group
ID Numbers can be set between 0 and 32767. See statements SEND and SENDTO for further explanations.