Lenze 931W - Manual (Page 50)

Accessories
Function modules for 930 series (M/W)
9

50 GHB 13.0002-EN 3.1
9.3 Function modules for 930 series (M/W)
For the servo inverters of the 930 series, function modules are provided to increase the
number of the digital inputs and outputs of the servo inverter. Further function modules
-e.g.forevaluatinganalog signalsor formaster frequencycoupling -are projected.Further
details on this can be received from your Lenze sales department.
For using function modules with a greater number of digital inputs and outputs, servo
inverters are to be used with a local CAN interface. The function modules are to be
connected to the servo inverters by means of a cable.

Stop!
The function modules are specifically designed for the L-force Servo Drives 930
fluxxtorque drive series. They are not compatible to the function modules (FIF
or AIF modules). FIF or AIF modules therefore cannot be used.
The type code of the function modules is as follows:
Type code of the function modules
930 - - - - - - - -
Series Type:
F: function
module
Interface:
C: local CAN
I: IO
Number of
digital inputs
Number of
digital outputs
Special function
Technical data of the function modules which can be connected to a servo inverter via a
local CAN interface:
Technical data of the 930FC140400function module
Digital inputs 14 (24 V)
Digital outputs 4 (24 V, max. 0.5 A output current)
Type of protection IP20
Special function None
General 36-pole screw terminal
Recommended cable for local CAN connection 491996
Technical data of 930FC030200application box
Digital inputs 3 (24 V)
Digital outputs 2 (24 V, max. 0.5 A output current)
Type of protection IP64
Special function None
General Each IO signal is lead out on a 3-pole M8 plug (digital
input: male, digital output: female).
Recommended cable for local CAN connection 491996