Lenze PLC Designer ApplicationTemplate (PLC Designer R3-x) - Manual (Page 156)

Application example: Flying saw
Creating and integrating machine modules
156
Lenze · ApplicationTemplate · 1.3 EN - 04/2013
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Right-click the A65 EmptyModule\MM_EmptyModule folder  Select  Copy Empty
Module.
2. Insert the previously copied machine module (Empty Module) below the
A70_MachineModuleSources folder:
Right-click the A70_MachineModuleSources  Insert Empty Module
3. Enter the module name.
Example: MM 2, infeed unit: Infeed
4. Click Insert to insert the machine module.
This is the way the five machine modules MM 2...MM 6 must be created.
The following machine modules must be created:
• B01_Infeed
• B02_Flying Saw
• B03_Outfeed
• C01_Slide
• C02_Blade
The highest machine control module, MM_ MachineControl, is
already included in the ApplicationTemplate.