Lenze PLC Designer ApplicationTemplate (PLC Designer R3-x) - Manual (Page 7)

Lenze · ApplicationTemplate · 1.3 EN - 04/2013
7
About this documentation
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Further technical documentation on Lenze products
Further information on Lenze products which can be used in connection with "Controller-
based Automation" can be found in the following documentation:
Target group
This documentation addresses to all persons who plan, commission, and program a Lenze
automation system on the basis of the Lenze "ApplicationTemplate" as part of the "Controller-based
Automation".
Screen shots/application examples
All screenshots in this documentation are application examples. Depending on the firmware
version of the Lenze device and the software version of the engineering tools installed (here: »PLC
Designer«), the representation of the actual screen display may deviate.
Mounting & wiring Symbols:
 MAs Controller  Printed documentation
 MA i700 servo inverter  Online help / PDF file
 MAs Servo Drives 9400
 MAs Inverter Drives 8400 Abbreviation:
 MA I/O system 1000 (EPM-Sxxx) BA Operating instructions
 MAs for communication cards (MC-xxx) KHB Communication manual
 MAs for communication modules MA Mounting instructions
SW Software manual
Parameterisation, configuration, commissioning SHB System manual
 SW Controller
 SW Servo-Inverter i700
 SW Servo Drive 9400 HighLine/PLC /
Regenerative power supply module
 9400 HighLine commissioning guidelines
 SW Inverter Drives 8400
StateLine/HighLine/TopLine
 SHB I/O system 1000 (EPM-Sxxx)
 BAs for servo system ECS (ECSxE, ECSxM)
 KHBs for communication modules
Programming

SW 9400 function library
Reuse

SW Application Sample i700
 SW Application Samples
 SW ApplicationTemplate