MK Diamond MK-101 Pro24 - Manual (Page 20)

20
MK-101 Pro24 SETUP
The Water Pump can be setup for operation in two ways, External Water Source or Re-circulation.
This is the preferred method of cooling.
NOTE: When using the re-circulation method, the water should be changed often for longer pump life.
WATER PUMP SETUP FOR OPERATION
EXTERNAL WATER SOURCE
RE-CIRCULATION
NOTE: If using a dry blade for operation, DO NOT connect the water pump.
1. Before powering or starting, check for damage that could prevent this equipment
from proper operation or performing it’s intended function. Check for binding and
alignment of moving parts. Check for damaged, broken, or missing parts.
2. Verify the On/Off switch is in the OFF position.
3. Before connecting the MK-101 Pro24 to a power supply, be sure the voltage, cycle
and phase of the job site power source meet the requirements.
CAUTION
(A)
Remove the Drain Plug.
Place empty container under
hole for water drainage
(B)
Place the Water Pump in an
external container and fill until
water completely covers the
Water Pump suction
(A)
Ensure the Drain Plug is in-
stalled in the Water Basin
(B)
Place the Water Pump in the
back of the Water Basin