MK Diamond MK-101 Pro24 - Manual (Page 28)

28
(A)
Clean the Water Pump
suction of all debris.
(B)
Place the Water Pump
In an external container.
(C)
Run the MK-101 until clear
water is seen at the blade
cooling ports (Approx. 1 min-
ute).
Ensure the saw is disconnected before completing the remainder of the
cleanup process.
(D)
Remove the Water Basin.
Ensure water is not forced into the motor casing when cleaning.
(E)
Clean the Movable Cutting
Table Guide Bar.
(F)
Clean the Movable Cutting
Table Roller Wheel Frame
Support.
(G)
Clean the remainder of the
MK-101.
CAUTION
CAUTION
MK-101 Pro24 CLEANUP
CLEANUP
NOTES: 1. If an external water source was used, steps A through C may be skipped.
2. Dispose of waste water in accordance with applicable Federal, State and Local laws.