MK Diamond MK-101 Pro24 - Manual (Page 27)

27
Hold the Post when removing the Retaining Bolts.
(A)
Ensure the ON/OFF Switch
is in the OFF position. Un-
plug the GFCI from the power
source.
(B)
Remove Water Basin and
Blade.
(C)
Remove the Cutting Head (See
Adjusting the Cutting Head.
(D)
Loosen the retaining bolts.
(E)
Remove the Standoffs and
retaining bolts together.
(F)
Relocate the Post to the rear
Post retaining holes.
(G)
Install and tighten with Standoffs
and retaining bolts.
(H)
Install the Cutting Head (See
Adjusting the Cutting Head.)
(I)
Install the Water Basin and
Blade.
CAUTION
CAUTION
MK-101 Pro24 ADJUSTMENT
ADJUSTING THE POST FOR MAXIMUM CUTTING LENGTH
The Cutting Head and Post are heavy! Use care when changing the position of
the Cutting Head.