MK Diamond MK-101 Pro24 - Manual (Page 23)

23
(A)
Remove the Adjustable
Cutting Guide.
(B)
Position the Dual 45º Flat Angle
Guide and tighten the
retaining thumbscrew.
(D)
Verify proper cooling flow on
both sides of the blade (See
Maintenance Section to
increase/decrease flow).
(E)
Perform the cut. Turn the motor
OFF when work is complete.
CAUTION
(C)
Place tile on the Cutting Table.
MK-101 Pro24 ADJUSTMENT
DIAGONAL CUTTING
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for
which it was designed.
NOTE: To cut diagonal, the Dual 45º Flat Angle Guide (MK Diamond Part No. 134577-MK)
should be used.