MK Diamond MK-101 Pro24 - Manual (Page 32)

32
DIAMOND BLADE CHANGE-OUT
MK-101 Pro24 MAINTENANCE
(A)
Locate the Shaft Lock push-
button on the underside of the
Cutting Head.
(B)
Remove Retaining Nut and
Outer Flange, depress and hold
the Shaft Lock pushbutton and
loosen.
(C)
Remove the Diamond Blade.
(D)
Install the Diamond Blade
onto Blade Shaft.
(E)
Verify the Blade is seated on
the Blade Shaft and direction
of rotation is correct.
(F)
Install Retaining Nut and Outer
Flange, depress and hold the
Shaft Lock pushbutton and
tighten Retaining Nut.
NOTE: When installing the Retaining Nut, do not “cross-thread” and DO NOT over tighten
the retaining nut.