MK Diamond MK-101 Pro24 User Manual
Page 37
Advertising

37
(A)
Allow the motor to cool and
depress motor Overload
Reset Switch. If motor does not
start, go to Step B.
MK-101 Pro24
TROUBLESHOOTING
BLADE STOPS TURNING
Verify circuit breaker at least 20 amps - if not, move to 20-amp circuit.
Verify circuit breaker is not tripped. If tripped, reset.
Check power source voltage is 120V - if not 120V, move to another circuit.
NOTE:
(B)
Verify all plugs fully installed.
Check Ground Fault Circuit
Interrupter
Advertising
This manual is related to the following products: