MK Diamond MK-212 - Manual (Page 19)

19
MK-212 SAW SETUP
WATER PUMP SETUP FOR OPERATION
The Water Pump can be setup for operation in two ways, External Water Source or Re-circulation.
NOTE: If using a dry blade for operation, DO NOT connect the water pump.
EXTERNAL WATER SOURCE
This is the preferred method of cooling.
(A)
Remove water pump from water
pan.
(B)
Remove the Drain Plug.
(C)
Place the Water Pump in an
external container.
(D)
Fill the external container until
water completely covers the Water
Pump suction.
(E)
Place an external catch basin
below the Water Basin drain hole.
RE-CIRCULATION
NOTE: When using the re-circulation method, the water should be changed often for longer pump life.
(A)
Install drain plug in drain hole in
bottom of water pan.
(B)
Fill the Water Basin until water
completely covers the Water
Pump suction.