MK Diamond MK-212 - Manual (Page 27)

27
MK-212 SAW MAINTENANCE
DIAMOND BLADE CHANGE-OUT
NOTE: When installing the Retaining Nut do not “cross-thread" and DO NOT over tighten the
screw.
(A)
Loosen the Cutting Head Locking
Knob.
(B)
Move the Cutting Head to one
end of the saw. Tighten the
Cutting Head Locking Knob.
(C)
Loosen the Cutting Head
Height Lock. Raise the cutting
height. Retighten Cutting Head
Height Lock.
(D)
Loosen the Blade Guard Pivot
Point Retaining Wingnut.
(E)
Loosen the Blade Guard Retaining
Knob.
(F)
Open the Blade Guard.
(G)
Loosen and remove the Blade
Retaining Nut.
(H)
Remove the Outer Flange.
(I)
Remove the old Diamond Blade.