MK Diamond MK-212 - Manual (Page 24)

24
CLEANUP
NOTES: 1. If an external water source was used, steps A through C may be skipped.
2. Dispose of wastewater in accordance with applicable Federal, State and Local laws.
MK-212 SAW CLEANUP
(C)
Run the saw until clear water is
seen at the blade cooling ports
(Approx. 1 minute).
(A)
Clean the Water Pump suction of
all debris.
(B)
Place the Water Pump in an
external container.
(D)
Ensure the ON/OFF Switch is in
the OFF position.
(E)
Unplug the GFCI from the Power
source.
CAUTION
(F)
Unplug MK-212 from the GFCI.
Ensure the saw is disconnected before completing the remainder of the cleanup
process.
(G)
Clean the MK-212 with soap and
clean water.
(H)
Drain the Water Pan and dispose
of the water in accordance with all
State, Local and Federal laws.
(I)
Clean the Water Pan.